A Fireside company - serving Winchester, NV

Lennox Heat Pump Service in Winchester, NV

Heat pumpsHeat pumps
AC repairAC repair
Furnace & heatingFurnace & heating
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Lennox Heat Pump Service: The Winchester Owner’s Guide

When a Lennox heat pump in Winchester needs a part replaced, the installed cost usually lands between $150 and $650 for a repair, and most of these jobs are completed in a single visit. We answer the phone around the clock, and if your system quits at 2 a.m. on a 108-degree July night in Winchester, a live person picks up and we get you scheduled. Replacement parts compatible with Lennox equipment are available, and we source the correct one for your model before we roll.

Call (844) 783-5043

Most Winchester owners don’t discover a failed part from a spec sheet. They notice it from the symptoms: the outdoor unit humming but not starting, the house warming up a couple degrees an hour, or a system that runs nonstop and never quite satisfies the thermostat. This guide is for the homeowner who already suspects it’s a part problem, knows there’s a Lennox badge on the condenser, and wants the swap matched to the right model, priced honestly, and finished fast.

Which Lennox Models This Applies To

Lennox has built heat pumps across several product lines, and the circuit boards, contactors, capacitors, reversing valves, and fan motors inside them are not universal. A capacitor sized for one tonnage will fail fast in another. A control board from a different series won’t communicate with your air handler. The model and serial plate on the outdoor unit (usually a silver sticker on the side panel near the service valves) tells us the series, tonnage, and refrigerant type. Bring us a photo of that plate, or read off the numbers, and we can order the correct replacement before we arrive.

The serial number also dates the equipment. Lennox encodes the manufacture date in the serial prefix, which matters more in Winchester than in cooler markets. Heat pump compressors and reversing valves here run hard through six months of desert summer, cycling thousands of times between May and October. A part that might last fifteen years in a mild climate often sees closer to ten here. Knowing the age tells us whether a part swap is money well spent or a band-aid.

On the OEM-versus-aftermarket question, we’re straight with homeowners. For contactors, run capacitors, and fan motors, a quality aftermarket equivalent built to the same electrical spec is a square deal and saves real money. For control boards and reversing valves, factory parts are usually the right call, because the tolerances matter and an aftermarket board can cost you a second service call. We charge no overtime and price the job upfront. We’re an independent service company and not affiliated with Lennox; we work on their equipment because it’s good equipment and our technicians know it.

Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Signs Your Lennox Heat Pump Service Is Failing

Here’s what a failing part looks like from the homeowner’s side of the thermostat.

  • The outdoor unit hums but the fan won’t spin. Nine times out of ten that’s a weak run capacitor, a start capacitor, or a seized fan motor. The compressor may be trying to start without it and tripping a breaker or thermal overload, which is why you’ll sometimes see the unit reset itself overnight.
  • The system runs but blows warm air in cooling mode. That points to a reversing valve that’s stuck, a failed defrost board, or a compressor contactor that isn’t pulling in. In Winchester, a reversing valve that sticks in heating mode leaves you with a cool house in July and a service call everyone wants done today.
  • The heat pump won’t switch between heating and cooling. A control board or thermostat interface that’s lost communication. Lennox communicating systems are picky about the right board pairing, which is why we match the part to the model, not just to the brand.
  • Ice on the outdoor coil in heating season, and it never defrosts. A defrost control board or the defrost sensor has failed. Left alone, the compressor runs against a blocked coil and that gets expensive fast.
  • The unit trips the breaker repeatedly. Could be a shorted compressor, a failing contactor, or a wiring fault. This one is not a wait-and-see symptom; it’s worth a call the same day.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For Winchester homeowners, most Lennox heat pump part replacements installed run between $150 and $650 for a repair. The price quoted is the price paid. Here’s what moves the range:

  • $150 – $280 for a run or start capacitor, contactor, or defrost sensor, parts and labor.
  • $250 – $450 for a fan motor or a control board, depending on whether the part is factory or a quality equivalent.
  • $400 – $650 for a reversing valve or a compressor-related repair that involves recovering refrigerant and recharging the system.

Those ranges reflect the real market here, not a loss-leader number that climbs on the invoice. Every repair is backed by our 90-Day Done Right Promise in writing, on the work we do. And if you get a written estimate from another company and want a Free Second Opinion before deciding, we’ll give you a straight read on it.

DIY or Call Us?

One honest paragraph on this, because heat pump parts are not all safe to handle yourself. The outdoor unit’s capacitors hold enough charge well after the power is off to hurt you badly, and the compressor circuit runs at high amperage. Pulling a capacitor or a control board without discharging and locking out the power correctly is how people end up in the emergency room. We’ll say it plainly: the parts swap is a job for a trained technician, not a Saturday project.

What you can safely check on your own: the breaker at the panel, the thermostat setting and batteries, the air filter, and whether the outdoor unit’s fan is physically cleared of debris. You can also read off the model and serial numbers so we order the right part before we come.

If it’s already failing, call us at (844) 783-5043. A live person answers, day or night, and we’ll quote you upfront before any work starts.

FAQs

Need HVAC help nationwide? Licensed & insured · 60-minute response · free estimates
Call (844) 783-5043
Local Service Coverage

Request a Free Estimate in Winchester

Tell us what you need - Fireside Heating & Air Co. Winchester responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch